liqui moly hydraulic lifter additive review!

how to silence the engine?

My car is a 2005 Hyundai coupe.
As the year and year of operation is old, the valve lifter noise has usually been very noisy.So I was searching for a way to reduce the valve lifter sound, and I found a RiquimolI product.

Why does the lifter make a ticking sound?
The hydraulic lift is self-adjusted. They will tick when something loses their internal oil pressure. If the inside of the lifter becomes dirty due to a lack of regular oil change, pressure loss may occur. This issue may also occur without the use of a suitable weight oil, which prevents the lifter from bleeding from the engine or filling the engine quickly enough when the engine is switched off.

 

solve the problem.
Oil additives can be used to avoid oil leaks and reduce noise to help troubleshoot engine problems for quieter operations. As for general issues, the use of additives enables economical long term repair without major expensive repairs. High load applications such as high-performance driving and towing will wear the engine much faster than normal driving. Use high quality fuel and oil additives combined with motor oil specified by the manufacturer to maximize the actual service life of the engine.

 

Clean the valve, guide the valve and promote optimum operation without affecting the oil viscosity. Suitable for all petrol, diesel and LP gas engines. Compatible with all commercially available mineral and synthetic motor oils. Safe and effective for turbocharger and supercharged engines. The use of the tappet stop noise additive allows the hydraulic lifters to function optimally by cleaning valves, guides and bores and does not affect oil viscosity. This is a much cheaper fix compared to replacing all of the tappets, which can be quite expensive. Tappet stop noise is an easy-to-use product with simple instructions printed on the back of a 300ml can. It is readily available from most car retailers.

 

liquui moly hydrauilc lifter additive review.

how to use hydraulic lifter additive oli. put the engine in for 10 minutes after preheating it, and allow it to idle for 10 minutes to dilute the engine oil.
Its viscosity is high, so when injected too quickly it overflows. You must position slowly.

 

 

In cold weather, the motor oil may not start properly due to the high viscosity of the oil during the initial start, so you should warm it up for two minutes before you start.

It has been 3 days since the injection. Valve lifter noise is significantly reduced and driving performance is slightly increased.